Friday, July 22, 2022

Seat Supports

The seat supports are in!

They are made from 2 pieces of 9mm ply. Here one is cut and the other drawn out.


Pattern for the supports. Each was a little different. 


Laminating the two pieces.


Gluing them in. The weights of course are holding them in place.


Fillets done.



 

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • First Overnighter
    First overnighter is in the books.  Forecast for Monday into Tuesday morning was good. Good breeze for the evening, clear skies through the ...
  • G17 "The Gathering" 2023
    I went to the Glen-L Gathering again this year. This makes about 4 times that I've been to it. I took Pixie, Little Bit to at least one;...
  • My Builds
      Pixie      I've always had a hankering to build with my hands. After I took up sailing, this easily morphed into a desire to build a b...